ALOM Oxy Scav 70
ALOM Oxy Scav 70
ALOM Oxy Scav 70 is a water/glycol soluble, synergistic formulation of low molecular weight oxygen scavenging molecules giving a good ratio mole scavenging, cost-efficiency in compared to many scavengers. The chemical demonstrates excellent characteristics over a wide range of scavenging applications and is an effective
passivating agent in normal applications. This chemical has a pH buffer reserve.
passivating agent in normal applications. This chemical has a pH buffer reserve.
PRODUCT
-
Oxygen Scavenger for Glycol Systems
APPEARANCE
-
?
DENSITY at lb/gal
-
8.15
pH ( 1 % Solution )
-
10?
Viscosity, cps @ 25 ° C
-
50
Flash Point
-
100 ° C?
General Information
ALOM-Oxy Scav 70 , is a carefully selected formulation of Oxygen reactive scavenger molecules chosen to be efficient in water, and glycol dehydration systems in associate gas drying and steam and boiler feed applications
- ü Stability : The components are thermally stable up to 300 psig (21 bar).
- ü Vapour distribution: Its vapor liquid distribution ratio of one of the concentrates in the formulation is 1.26. This
means that there will be approximately 1.26 ppm of this scavenger in the vapor phase of the system for every 1
ppm of the active matter in the liquid phase. Therefore, this scavenger will partition in the system vapour and
liquids and in cool spots affording added protection to any corrosion inhibitor that is /may be used. - ü Blowdown or venting: Natural solids may build up in the condenser knock out drums. It’s essential to blow down
the condensers. Acidic gases from the gas system or thermal degradation of glycols can cause salt formation. If the
system foams, salts travel into the condenser boxes and require cyclical blowdowns, which is a standard operating
procedure. The volatility of our scavenger or any special scavenger for glycol systems running at increased
temperatures means that the scavenger has to control oxygen in the vapour phase also. If required in higher
dosages, then there is a normal process to adequately vent to remove non-condensable gases, oxygen and
amines. These could be trapped in knockout vessels. - ü Dissolved and dispersed Solids: Our chemical scavenger molecules and its reaction products will not contribute
to solids in the glycol system from oxygen scavenging. Note some associated gases in oil production will contain
acetic acids, hydrogen sulphide, carbon dioxide and mercaptans. Some of these have in the practice contributed to
solids from the corrosion inhibitor and neutralizing amines and inorganic buffers used in glycol systems. If
dispersed in the glycol, these are removed by glycol cartridge filter units. Entrained crude oils, asphaltenes and
formation salts, dirt are found with solids in the glycol systems are easily filtered off.
PRODUCT APPLICATION
ALOM-OxyScav 70 is recommended for use as an oxygen scavenger in glycol, steam and steam reboiler systems. At low dosages it can be used to enhance de-aeration systems for water. In glycol systems, medium dosages, it can be used in maintaining cleanliness from dissolved iron reactions with oxygen.
- ü LIMITATIONS: ALOM-OxyScav 70 has some buffering functions and if there are doubts about compatibility, bottle
tests should be performed. - ü TREATMENT REQUIREMENT: Oxygen scavenger requirements will vary according to the system variables,
obviously temperature, pressure and retention times will affect efficiencies. A ratio of 2 mg/L of ALOM-OxyScav
70 per 1 mg/L of dissolved oxygen is recommended as the treatment rate. - ü FEEDING: ALOM-OxyScav 70 may be fed directly from the drum or diluted with glycol, water or mixtures thereof -
A blend should be checked before use. - ü BATCH TREATMENT: A tank of water or glycol can be batch treated to tanks being filled or filled, recirculate, and
settle to react out the oxygen.
ALOM-OxyScav 70 can be injected with a normal chemical proportionating pump for continuous injection.
PACKING
Ð ALOM INHIB 50 –Is available in below Packing :-
- V 55 Gallon Plastic Drums
- v 1000 Liters IBC Tanks
HEALTH INFORMATION
After skin contact wash immediately with soap and water and rinse thoroughly; if skin Irritation continues, consult a doctor. After eye contact the opened eye should be rinsed for 15 minutes under running cold water, and then a doctor must be consulted. Additional information concerning first aid is given in the Material Safety Data Sheet, which is available upon request.
STORAGE AND HANDLING
ALOM Oxy Scav 70 should be stored in epoxy / phenolic lined polyethylene or SS containers. ALOM Oxy Scav 70 is stable for at least one year if stored at temperatures of
between – 10 and + 50 o C in the original sealed container. When handling ALOM Oxy Scav 70, protective gloves, tightly sealed goggles and protective work clothing should be
worn. Use with adequate ventilation & keep containers closed to prevent product contamination. Additional information concerning fire fighting measures, transport information and regulations is given in the Material Safety Data Sheet, which is available upon request.
between – 10 and + 50 o C in the original sealed container. When handling ALOM Oxy Scav 70, protective gloves, tightly sealed goggles and protective work clothing should be
worn. Use with adequate ventilation & keep containers closed to prevent product contamination. Additional information concerning fire fighting measures, transport information and regulations is given in the Material Safety Data Sheet, which is available upon request.
OUR STATEMENT
Ð The statements made in the above documents are correct to the best of our knowledge and belief. Alpha Omega Chemicals Pvt. Ltd., gives no warranty as to their accuracy and will not be responsible for any loss or expenses arising from use of these products